30
If learning is completed successfully, it is indicated with the
flashing green LED (length of time depends on whether it is still
configuring).
Note: If the remote control is already taught for a center
and therefore is blocked for direct training, it can still be
put in teach mode as described above, the device LED is
illuminated in red for 2 seconds after pressing an operating but-
ton however. Direct teaching is not possible!
Min. 2 sec. green LED
Teaching successful
2 sec red LED
Teaching failed
Orange flashing
Only remote control in
Teach mode
Remote control in configu-
ration mode and illuminated
red with button actuation
Remote control already taught
for center and is therefore
blocked from direct teaching
7
Operation
7.1
Simple operating functions
After teaching, simple operating functions are available.
The 16 buttons on the remote control are taught as eight sepa-
rate button pairs (ON/OFF) for one receiver upon delivery, de-
pending on from which pair the button was pressed for teaching.
Switch actuators and dimmers can then be switched ON/OFF or
dimming occurs by holding the button pressed. The blind actua-
tors move up or down. The three special buttons located on the
side of the remote control are only functional in combination with
the HomeMatic Central.
The remote control is equipped with a vibration sensor.
The background lighting of the button field is illuminated for 5
