27
capacity. If the rechargeable battery life should be decreased
by one or two days for normal remote control usage or if the
charge battery indicator is shown again even after charging, the
rechargeable batteries must be replaced with new recharge-
able batteries of the same type Micro NiMH (HR 03, capacity
of at least 1000mAh). Following the instructions in the previous
chapter in this case.
6.1.3
Behavior after inserting charged batteries
Rechargeable batteries that have been charged in an external
charger can also be inserted.After inserting the rechargeable bat-
tery, the remote control will run a self-test. This runs for approx. 2
seconds. The initialization runs next. The completion is indicated
with the LED test display: red, green, orange, each for a half
second. If an error occurs, it is indicated with red flashing!
One long flash, two short flashes,
pause (repeated twice)
Battery power too
low
One long flash, one short flash, pause
(infinite)
Remote control
defective
If the battery power is low, as long as the power level allows,
the button actuation is activated and the remote control is ready
for operation. Depending on the requirements, the battery may
recover and send again many times after a short break. If the
power drops too low when sending, the respective error code is
displayed. The symbol for low battery is shown on the display of
the remote control.
If the behavior of the remote control is undefined, put
the remote control in the charger. The remote control is
then supplied through the charging station and should
indicate normal behavior. Charge the rechargeable batteries of
the remote control for a longer period of time in such cases.
