OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
31
ZX40PC
17.2.5
Moving the cross table
You can move the cross table in the X and Y directions to
position the drill/mill in the correct position.
In X-direction there are also 2 limiting pins (1) available
which can limit the movement in X-direction by moving
it.
- The fixing screws on the front X axis (3) and on the left
of the worktable Y axis (2) must be loosened to move the
table. Position the table in the desired position by turning
the handwheel (4).
N O T E
When drilling, the cross table should always
be fixed to achieve an optimum drilling
pattern and to avoid/minimise vibrations.
17.2.6
Working table Height adjustment / tilting
You can adjust the height and angular position of the worktable/cross
table.
To position, loosen the clamping screws (2) with a fork wrench and
adjust the height with the crank handle (1) and the angular
position by turning the worktable.
After the desired height position and angular position have been
achieved, retighten the clamping screws (2.
17.2.7
Setting the height position of machinehead/spindle
The required height position of the machine head to the
cross table can be adjusted by means of the hand crank.
1. Loosen the two fixing screws (3).
2. move the machine head to the desired height position by
means of the hand crank (1)
3. tighten the two fixing levers (3) again to fix the position
17.2.8
Setting the angular position of machinehead / spindle
The machine head (1) can be swivelled within the technical
specifications.
To do this, loosen the 3 screws (1..left, 2..middle, 3 right of
the head) and swivel the machine head to the desired angular
position, which is indicated on the scale (5). Then tighten the
3 screws again.
