TRANSPORT
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
25
ZX40PC
14.6
Special Safety Instructions for that machine
Secure the workpiece to be machined against entrainment by the tool. Use a machine vice
or clamping claws for clamping.
Remove the clamping key from the chuck after each tool change.
Do not wear gloves when working on rotating parts!
Keep sufficient distance from all rotating parts.
Never remove chips by hand! Use a chip hook, rubber wiper, hand brush or brush.
When using cooling lubricants, observe the manufacturer's instructions and, if necessary,
use a skin protection agent.
14.7
Hazard Warnings
Despite the intended use, certain residual risks remain. Due to the design and construction of the
machine, hazardous situations may occur when handling the machines, which are identified in
these operating instructions as follows:
D A N G E R
A safety instruction designed in this way indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
W A R N I N G
Such a safety instruction indicates a potentially hazardous situation which, if not
avoided, may result in serious injury or even death.
C A U T I O N
A safety instruction designed in this way indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate injury.
N O T E
A safety notice designed in this way indicates a potentially hazardous situation which,
if not avoided, may result in property damage.
Irrespective of all safety regulations, your common sense and appropriate technical
suitability/training are and will remain the most important safety factor for error-free operation of
the machine. Safe working primarily depends on you!
TRANSPORT
W A R N I N G
Damaged or insufficiently strong hoists and load slings can result in serious injury or
even death. Before use, check hoists and load slings for sufficient load capacity and
perfect condition. Secure the loads carefully. Never stand under suspended loads!
To ensure proper transport, also observe the instructions and information on the transport
packaging regarding centre of gravity, attachment points, weight, means of transport to be used
and the prescribed transport position, etc.
Transport the machine in its packaging to the installation site. To manoeuvre the machine in
the packaging, a pallet truck or forklift truck with the appropriate lifting force can be used, for
example.
NOTICE:
In order to lift the machine from the pallet, you need a rope/hoists with sufficient
load-bearing capacity.
1.
Place the hoist/rope around the machine to prevent it from slipping.
2.
Place soft, non-slip materials between the belt and the machine.
3.
Align the belt lengths so that the machine is horizontal and stable when lifted.
4.
Bring the worktable into centred position in the transverse axis.
5.
Lock the machine completely.
6.
The steel cables must not touch the machine body, lever, etc.
7.
Gently lift the machine to avoid shocks and load fluctuations and carefully transport it
to the installation site.
