HOLZMANN MASCHINEN TK255, Руководство пользователя

Страница: 39 / 127

TROUBLESHOOTING
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 39
TK255
17.2.5 Check /exchange carbon brushes
Check the carbon brushes after the first 50 hours of operation
with a new machine or when new brushes are fitted. After
carrying out the first check, repeat the check every 10 hours of
operation. If the carbon is worn to a length of 6 mm, or if the
spring or contact wire is burnt or damaged, it is necessary to
replace both brushes. If it turns out that the brushes are usable
after removal, it is possible to refit them.
When servicing the carbon brushes, open the two latches
counterclockwise. Then remove the carbon brushes. Replace the
carbon brushes in reverse order.
17.2.6 Overload-protection
 Disconnect the machine from the power supply
 Allow the machine to cool down
 Check the machine for possible damage
 Any damage must be repaired before switching on
again!
 Reconnect the machine to the power supply
 Press overload switch (k)
17.3 Storage
NOTE
Improper storage can damage and destroy important components. Only store
packed or unpacked parts under the intended ambient conditions!
When not in use, store the machine in a dry, frost-proof and lockable place to prevent the
formation of rust on the one hand and to ensure that unauthorised persons and in particular
children have no access to the machine.
17.4 Disposal
Observe the national waste disposal regulations. Never dispose of the
machine, machine components or operating materials (like oil,…) in residual
waste. If necessary, contact your local authorities for information on the
disposal options available.
If you buy a new machine or an equivalent device from your specialist
dealer, he is obliged in certain countries to dispose of your old machine
properly.
TROUBLESHOOTING
WARNING
Danger due to electrical voltage! Manipulating the machine with the power supply
up can lead to serious injuries or death. Always disconnect the machine from the
power supply before carrying out any troubleshooting work!
Many possible sources of error can be excluded in advance if the machine is properly connected
to the mains.
If you are unable to carry out necessary repairs properly and/or do not have the required
training, always consult a specialist to correct/solve the problem!.