HOLZMANN MASCHINEN TK255, Руководство пользователя

Страница: 36 / 127

CLEANING, MAINTENANCE, STORAGE, DISPOSAL
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 36
TK255
Sawing vertical mitre angles
-
Set the desired vertical mitre angle of the saw blade.
The saw blade is tilted to the left here to avoid possible contact with the saw blade, the rip
fence must be to the right of the saw blade or, if it is mounted on the left, the stop bar must
be attached to the rip fence on the right and the distance to the saw blade must be checked.
- Adjust the rip fence to the desired cutting width.
- Place the workpiece on the saw table in front of the saw blade cover.
- Adjust the saw blade height so that the upper teeth are approx. 3-6 mm above the workpiece.
- Switch on the machine
- Saw through the workpiece at a steady feed rate.
- If you apply too much pressure, the saw blade tips may overheat and the workpiece may be
damaged.
- Switch off the machine when you have finished sawing and wait until the saw blade has come
to a complete stop
Sawing horizontal mitre angels
- Set the desired mitre angle on the mitre/angle fence.
- Place the workpiece against the angle stop.
- Set the saw blade height so that the upper teeth are approx. 3-6 mm above the workpiece.
- Switch on the machine
- Press the workpiece against the angle stop with one hand and slowly push it forward in the
guide groove with the other hand.
- After the sawing process is finished, switch off the machine and wait until the saw blade has
come to a complete stop.
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
WARNING
Danger due to electrical voltage! Handling at the machine with upright power
supply can lead to serious injuries or death. Always disconnect the machine from
the power supply before cleaning, servicing or maintenance work and secure it
against unintentional reconnection!
17.1 Cleaning
NOTE
Wrong cleaning agents can attack the varnish of the machine. Do not use solvents,
nitro thinners, or other cleaning agents that could damage the machine's paint.
Observe the information and instructions of the cleaning agent manufacturer!
Regular cleaning is a prerequisite for the safe operation of the machine and its long service life.
 Therefore, clean the machine after each use and remove any sawdust with a brush, broom or
vacuum cleaner.
17.2 Maintenance
The machine is low-maintenance and only a few parts have to be serviced. Nevertheless,
malfunctions or defects which could impair the safety of the user must be rectified immediately!
 Before each operation, check that the safety devices are in perfect condition.
 Regularly check that the warning and safety labels on the machine are in perfect and legible
condition.
 Use only proper and suitable tools.
 Only use original spare parts recommended by the manufacturer.