OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
35
TK255
16.2.4
Adjusting angle/mitre stop
Release the angle stop lock (2).
Set the desired angle
Lock the angle stop (2) again.
The position of the fence can be adjusted by
loosening the screw (2) and sliding it.
ATTENTION: Check the distance to the saw blade and
readjust if necessary.
16.2.5
Switching machine ON/OFF
Switch the machine ON:
Press the ON button (I)
Switch the machine OFF:
Press the ON-OFF switch (0)
16.2.6
Existing storage places
A spare saw blade is stored with the spare saw blade
attachment (1).
The rip fence is stored in slot 2
The push stick is stored in slot 3.
The power cord is stored in the power cord holder
(4).
The tool is stored in the tool compartment
The angle stop is stored in the slot (5)
16.3
Operation modes
Sawing straight cuts
– Position the rip fence to the desired cutting width.
- Place the workpiece on the saw table in front of the saw blade cover.
- Adjust the saw blade height so that the upper teeth are approx. 3-6 mm above the workpiece.
- Switch on the machine
- Saw through the workpiece at a steady feed rate. If you apply too much pressure, the saw
blade tips may overheat and the workpiece may be damaged.
- Switch off the machine when you have finished sawing and wait until the saw blade has come
to a complete stop..
Содержание TK255
Страница 117: ...HOLZMANN MASCHINEN GmbH www holzmann maschinen at 117 TK255 ...
Страница 127: ......