OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Seite 35
METALLDREHMASCHINE / METAL TURNING LATHE ED 300FD
14.2.3
Setting the direction of spindle rotation
Turn on the direction of rotation switch (
1
) to the position
˝ F ˝
for spindle
mode counterclockwise, and in the position
˝ R ˝
for spindle mode clockwise.
In the position
˝ O ˝
is switched to idle
C A U T I O N
Wait at each change of direction necessarily, the machine stops, otherwise
the machine may be damaged!
14.2.4
Clamp Tool
The tool must be clamped.
During the rotating operation of the tool has a tendency to bend away from the workpiece.
Therefore, the tool overhang on the tool holder
3
/8
" (~
9
mm) should not exceed.
The cut angle is correct if the cutting edge is in line with the central axis of the workpiece. The
correct height of the tool can be achieved by comparing the tool tip with the live center in the
tailstock tip.
If necessary, the tool must be adjusted by using the same documents. ( Available from Holzmann
under item number PU7TLG95 and PU7TLG150 )
14.2.5
Leveling tailstock to headstock
Tighten properly between spindle and tailstock up a
305
mm long solid piece of pipe.
Cock now in the tool holder has a digital Display one.
200mm
Содержание ED 300FD
Страница 54: ......
