HOLZMANN MASCHINEN ED 300FD, Руководство пользователя

Страница: 33 / 54

ASSEMBLY
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at Seite 33
METALLDREHMASCHINE / METAL TURNING LATHE ED 300FD
13.3 Assembly
13.3.1 Cleaning
Remove the anti-corrosion protection and grease before putting the machine through kerosene
(paraffin) or turpentine of all tours and the transmission. Do not use thinner or other strong sol-
vents. Lubricate all the bright faces of the machine directly after its cleaning. Do not use heavy oil
or grease for the gearbox.
13.3.2 Installation
Place the lathe on a solid surface. A concrete floor is the best foundation for the machine, if ne-
cessary, use a base. Make sure that you have enough space around the machine to optimally op-
erate and maintain. Adjust the guides exactly a bed, then tighten the foundation bolts evenly and
finally check the stand.
13.4 Electrical connection
13.4.1 Earthing connection
A T T E N T I O N
When working on an ungrounded machine:
Serious injury due to electric shock in the event of a malfunction possible!
Therefore: appliance must be grounded and operated on a grounded outlet can be
The electrical connection of the machine is ready for operation on a grounded outlet!
If a plug is supplied, this must only be connected to a properly fitted and grounded electrical out-
let!
The plug (if supplied) must not be changed. If this does not fit or is defective, only a qualified
electrical engineer may modify or replace the plug!
The grounding conductor is green-yellow!
In the event of repair or replacement of the grounding conductor must not be connected to an
under voltage can!
Check with a qualified electrician or service that the grounding instructions are understood and
the machine is grounded!
A damaged cable must be replaced immediately!
13.5 Before commisioning
 removing the mounted for the transportation and storage of corrosion inhibitors on the lathe .
We recommend this petroleum.
 To clean, use any solvents, nitrocellulose thinner or other cleaning agents that might damage
the paint of the lathe. Please read the information and instructions of the detergent manufac-
turer .Lubricate all a bare machine parts with an acid-free lubricating oil.
 Function of the movable and fixed parts of control
 Lubricate the lathe from according to lubrication chart.
 Check all screws for ease of movement .
 Check that the fixing screws of the chuck are tight .