Holiday 2011 Aluma Lite, Руководство пользователя

Страница: 129 / 190

127
w
a
t
e
r
s
y
s
t
e
m
s
-
6
WATER - pOTABLE
Fresh Water Fill
When connecting the
motorhome to fresh water,
use a hose manufactured and
labeled “for potable water.”
This ensures that the hose will
not flavor the water. Install a
pressure regulator on the water
line to prevent the hose from
expanding and bursting due to
excessive pressure.
Ensure the water pump is
off.
Connect one end of the
pressure regulator to the water source
and the other end to the potable hose.
Connect potable hose to the City/Fresh
Water Fill inlet.
Open the winterization valve.
Make sure the fresh water tank drain
valve and all low point drain valves are
closed.
Turn the water control handle to the
Tank Fill position.
Turn on water at the water source. The
water should be audible as the fresh
water tank fills. Observe tank fill by
using monitor panel located inside the
motorhome.
Frequently press the Test switch and
read the scale as the fresh water tank
fills. Do not leave the motorhome
unattended while filling the fresh water
tank.








The tank is nearing full when the light
marked F illuminates. When the tank is
completely full, water will flow out of
an overflow tube under the motorhome.
Turn off water supply and return the
water control handle to City Water
position.
Disconnect the potable hose. Remove
pressure regulator. Store the hose with
both ends connected to prevent debris
from entering the hose.
CAUTION
Some outside water sources develop
high water pressure, particularly in
mountainous regions. High water
pressure is anything over 55 psi (pounds
per square inch). Excessive water
pressure may cause leaks in water lines
and/or damage the water heater. Excess
pressure can cause the water hose to
swell and burst. It is recommended to
use a water pressure regulator.
City Water Hook-Up
When connecting the motorhome to fresh
waster, use a hose manufactured and labeled
for potable water to ensure the hose will not
flavor the water. It is recommended to install a
pressure regulator at the source to prevent the
hose from bursting due to excessive pressure.



Connect the pressure regulator to the
water source. Attach potable hose to
the pressure regulator to protect potable
hose from high pressure.
Connect potable hose to the City/Fresh
Water Fill inlet.
Turn the water control handle to the
City Water position.
Turn on the water at the source.
The water pump can either be off or
on. It will not affect the water pump to
leave it on.
Open each faucet, one at a time, to
purge any trapped air inside the pipes.
CAUTION
Some outside water sources develop
high water pressure, particularly in
mountainous regions. High water
pressure is anything over 55 psi (pounds
per square inch). Excessive water
pressure may cause leaks in water lines
and/or damage the water heater. Excess
pressure can cause the water hose to
swell and burst. It is recommended to
use a water pressure regulator.






040480y
040460o
040460p