Holiday 2002 NEPTUNE, Руководство пользователя

Страница: 250 / 344

Electrical Systems - House
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
2 0 0 2 N E P T U N E
8 • 250
The battery state indicator performs two functions. When not hooked to
shore power the Battery State indicator displays the approximate state of
charge of the house batteries. When connected to shore power or operating
from the generator, the lamps indicate what part of the charge cycle the
inverter is in.
• Red = Bulk Charge
• Yellow = Accept Charge
• Green = Float Charge
Battery Charger Circuit Breaker:
The circuit breaker for the charger is located on the front of the inverter.
The breaker is a re-settable breaker in case an over current or short circuit
condition occurs within the Battery Charger circuitry.
AC Out Circuit Breakers:
Two branch circuit breakers are located on the front of the inverter. One of
the branch circuit breakers supplies AC power to various receptacles. The
other breaker supplies AC power to the microwave.
The inverter may be placed in " STAND-BY " when hooked to shore power
or operating from the generator. If AC power discontinues, the inverter acti-
vates automatically. When AC power resumes, the inverter will go back to
stand-by mode.
STAND-BY mode is indicated by the INVERT status light
flashing once every two seconds when hooked to shore power or operating
from the generator.
To enable or disable this feature:
• Press the INVERT button.
NOTE: Remember to disable stand-by mode when not in
use. It may run down the house batteries.
Setting the Power Share amps can limit the amount of AC power available
to the internal charger. Battery charger draw can exceed 20 AC Amps. When
hooked to anything less than 50 Amp service it may be necessary, depending
on other AC loads, to adjust the Power Share amps to avoid overloading the
shore power breaker.
NOTE: Limiting the amount of useable current for the
charger increases the amount of time necessary to charge
the batteries.
Stand-By Mode
Battery State
Indicator
Circuit Breakers
Power Share