Holiday 2002 NEPTUNE, Руководство пользователя

Страница: 144 / 344

Appliances
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
2 0 0 2 N E P T U N E
4 • 144
• Make sure the LP-Gas supply valve is open.
• The furnace will not light if the blower motor is not spinning to
specified speed. This may be due to a low house battery charge con-
dition. Hook-up to shore power and start the generator or main
engine to charge the batteries.
• If the blower motor does not spin and the necessary power
requirements have been met, use a screwdriver or coin to open the
furnace access panel outside of the motorhome. Make sure the
ON/OFF switch is ON and the circuit breaker is pushed IN .
WARNING: If you smell gas and the blower motor is
spinning, do not attempt additional furnace operation.
This may result in an explosion, fire or personal injury.
Contact a qualified technician.
A six-gallon water heater is the standard feature for the motorhome. The
water heater operates by using one of two methods. The first method is 120
Volts AC, supplied either by shore power or the on board generator. The 120
Volt AC uses a heating element like the one found in a house water heater. The
120 Volt AC method is the more efficient if shore power is available.
The second method uses LP-Gas. The LP-Gas incorporates the use of an
Automatic Ignition circuit board operated by 12 Volt DC. Two thermostats con-
trol the water temperature, one for the 120-Volt and the other for the LP-Gas. The
water heater manufacturer presets the temperature of both thermostats.
The process for heating water is simply. Water is pumped into the bottom of
the water heater tank. LP-Gas, 120 Volt AC, or a combination of both, heats
the water. The heated water is discharged out of the top of the tank upon usage.
The water heater is equipped with a by-pass valve for easy winterization
and a Temperature Pressure Relief valve for safety. The water heater has
aluminum clad tank. An anode is not necessary.
NOTE: The automatic ignition circuit board will make
three attempts to light the burner. If the burner does not
light by the third attempt, the ignition circuit board will go
into "lock-out." Cycling the on/off switch will reset the igni-
tion board.
NOTE: Do not operate the water heater by either function
without water in the water heater tank. This can damage
the thermostats the tanks and the electric heating element.
WATER HEATER
If the Furnace Fails
to Light