8
START UP AND OPERATION
PRO 36 AUTO
3. STARTUP AND OPERATION
3.1. Mounting and operating the annular cutter
Unplug the power cord from the power outlet and raise the motor by rotating the
spoke handles clockwise (
1
, Figure 3). Insert the proper pilot pin into the annular
cutter (
2
), then wear protective gloves and place the cutter into the arbor (
3
) in such
a way to align the flats
4
with the set screws
5
. Finally, tighten both set screws with
the supplied 4 mm hex wrench. To dismount the cutter, proceed in reverse order.
Figure 3.
Mounting the annular cutter
PRO 36 AUTO Operator’s Manual
All safety precautions must be closely observed.
1
2
3
5
4
8
3. START UP AND OPERATION
All safety precautions must be adhered to.
3.1. Mounting and operating the annular cutter
Unplug the power cord from the power outlet and raise the motor by rotating the spoke
handles clockwise (1, Figure 3). Insert the proper pilot pin into the annular cutter (2), then
wear protective gloves and place the cutter into the arbor (3) in such a way to align the flats
4 with the set screws 5. Finally, tighten both set screws with the supplied 4 mm hex wrench.
To remove the cutter, proceed in reverse order.
PRO 36 AUTO
Figure 7.
Securing the drilling machine using the safety strap
When working in the position from Figure 7a, mount the cooling system bottle as
described before and
fill
it
with
a
cutting
fluid. Do not use pure water as the cutting
fluid, however, using emulsions formed from mixing water and drilling oil is also
satisfactory. To check the operation of the cooling system, slightly loosen the bottle
cap, open the valve using the lever, and initially apply pressure on the pilot pin by
rotating the spoke handles counterclockwise. The fluid should fill the system and
should begin flowing from the inside of the cutter.
Enter into manual feed mode by positioning the spoke handles as shown in Figure 8a,
and
rotate
them
counterclockwise
to
place
the
tip
of
the pilot pin above the drilling
point.
Figure 8.
Configuration of the spoke handles: manual feed (a), automatic feed (b)
PRO 36 AUTO Operator’s Manual
a)
b)
The cooling system works by means of gravitation, therefore use
a cooling paste when working in horizontal or inverted positions
.
12
Содержание Pro 35 Auto
Страница 15: ...15 NOTES...
