13
START UP AND OPERATION
PRO 36 AUTO
Figure 7.
Securing the drilling machine using the safety strap
When working in the position from Figure 7a, mount the cooling system bottle as
described before and
fill
it
with
a
cutting
fluid. Do not use pure water as the cutting
fluid, however, using emulsions formed from mixing water and drilling oil is also
satisfactory. To check the operation of the cooling system, slightly loosen the bottle
cap, open the valve using the lever, and initially apply pressure on the pilot pin by
rotating the spoke handles counterclockwise. The fluid should fill the system and
should begin flowing from the inside of the cutter.
Enter into manual feed mode by positioning the spoke handles as shown in Figure 8a,
and
rotate
them
counterclockwise
to
place
the
tip
of
the pilot pin above the drilling
point.
Figure 8.
Configuration of the spoke handles: manual feed (a), automatic feed (b)
PRO 36 AUTO Operator’s Manual
a)
b)
The cooling system works by means of gravitation, therefore use
a cooling paste when working in horizontal or inverted positions
.
12
When the cutter goes through the material, the slug
core is expelled from the tool with a significant force.
3.5. Drilling
Start the motor by pressing the green MOTOR button. Slowly rotate the spoke handles
counterclockwise to bring the cutter close to the workpiece. Then, gently begin drilling and
enter into the automatic feed mode by setting the spoke handles in the position shown in
Figure 8b. The drilling machine will automatically detect the end of the drilling, which will
stop the feed after the hole is accomplished, however, the motor will still be rotating.
Once the hole is accomplished, toggle the spoke handles into the manual feed mode
(Figure 8a). Then, retract the cutter from the workpiece and stop the motor using the
red MOTOR button. To move the machine to another drilling spot, first disable the
electromagnetic base by toggling the MAGNET switch to position ‘O’ (off).
Once the work is finished, unplug the machine from the power outlet, clean chips and
excess coolant from the machine and cutter, and remove the machine from the worksite.
Tighten the cap of the cooling system bottle, close the valve, and press the pilot pin
to expel the coolant remaining within the system. Before inserting the drilling machine into
the toolbox, disassemble the cooling system bottle and remove the cutter and pilot pin from
the arbor using protective gloves.
Содержание Pro 35 Auto
Страница 15: ...15 NOTES...
