HOLEMAKER Pro 35 Auto, Руководство оператора

Страница: 7 / 16

7
SAFETY INSTRUCTIONS
8. Untrained bystanders must not be present in the vicinity of the machine.
9. Before beginning, check the condition of the machine and electrical supply,
including the power cord, plug, control panel components, and cutters.
10. Keep the machine dry. Exposure to rain, snow, or frost is prohibited.
11. Never stay below the machine placed at heights.
12. Keep the work area well lit, clean, and free of obstacles.
13. Mount the annular cutter securely using the set screws. Remove adjusting keys
and wrenches from the work area before connecting the plug to the power outlet.
14. Never use dull or damaged cutters.
15. Mount and dismount cutters using protective gloves and with the power cord
unplugged from the power outlet.
16. Never use annular cutters without the pilot pin except when drilling incomplete
through holes.
17. Mount only annular cutters with the maximum drilling diameter of 36 mm (1.42’’)
and the maximum drilling depth of 55 mm (2.17’’).
18. Never use the machine in the vicinity of flammable liquids or gases, or in
explosive environments.
19. Using the machine on surfaces that are rusty, covered with a thick paint layer,
uneven, or not rigid is prohibited.
20. Use the safety strap in all operating positions. The strap must be tight and
fastened to a securely fixed element either through the opening in the machine
body or by catching the strap on the carrying handle. Never insert the strap into
the buckle from the front.
21. Before every use, inspect the machine to ensure it is not damaged. Check
whether any part is cracked or improperly fitted. Make sure to maintain proper
conditions that may affect the operation of the machine.
22. Always use eye and hearing protection and protective clothing during operation.
Do not wear loose clothing.
23. Proceed with caution when drilling plate with a thickness less than 10 mm (0.4’’)
as the adhesion force depends on material thickness and is significantly lower for
thin plate.
24. The entire surface of the electromagnetic base bottom must be in full contact with
the workpiece. Before every positioning, wipe the workpiece with coarse-grained
sandpaper.
25. Do not touch moving parts or chips formed during milling. Prevent objects from
being caught in moving parts.
26. After every use, remove metal chips and excess coolant from the machine. Do
not remove chips with bare hands.
27. Maintain the machine and tools with care. Cover steel parts with a thin grease
layer to protect them against rust when not in use for any extended period.
28. Perform maintenance only with the machine unplugged from the power outlet.
29. All repairs must only be performed by an ITM approved repairer or service agent.
30. If the machine falls on from any height, is wet, or has any other damage
that could affect the safe operation of the machine, stop the operation and
immediately send the machine to the service centre for inspection and repair.
31. Never leave the machine unattended during operation.
32. Remove from the worksite and store in a secure and dry location, when not in use
remove the cutter and pin from the arbor.