5
GENERAL INFORMATION
PRO 36 AUTO
1.3. Design
Figure 1.
PRO 36 AUTO design
PRO 36 AUTO Operator’s Manual
3
1
6
m
m
(
1
2
.4
’’)
313 mm (12.3’’)
221 mm (8.7’’)
arbor
spoke handle
carrying handle
control panel
electromagnetic base
chip guard
bottle valve lever
opening for safety strap
cooling system bottle
4
PRO 36 AUTO
Figure 7.
Securing the drilling machine using the safety strap
When working in the position from Figure 7a, mount the cooling system bottle as
described before and
fill
it
with
a
cutting
fluid. Do not use pure water as the cutting
fluid, however, using emulsions formed from mixing water and drilling oil is also
satisfactory. To check the operation of the cooling system, slightly loosen the bottle
cap, open the valve using the lever, and initially apply pressure on the pilot pin by
rotating the spoke handles counterclockwise. The fluid should fill the system and
should begin flowing from the inside of the cutter.
Enter into manual feed mode by positioning the spoke handles as shown in Figure 8a,
and
rotate
them
counterclockwise
to
place
the
tip
of
the pilot pin above the drilling
point.
Figure 8.
Configuration of the spoke handles: manual feed (a), automatic feed (b)
PRO 36 AUTO Operator’s Manual
a)
b)
The cooling system works by means of gravitation, therefore use
a cooling paste when working in horizontal or inverted positions
.
12
PRO 36 AUTO
1.3. Design
Figure 1.
PRO 36 AUTO design
PRO 36 AUTO Operator’s Manual
3
1
6
m
m
(
1
2
.4
’’)
313 mm (12.3’’)
221 mm (8.7’’)
arbor
spoke handle
carrying handle
control panel
electromagnetic base
chip guard
bottle valve lever
opening for safety strap
cooling system bottle
4
PRO 36 AUTO
1.3. Design
Figure 1.
PRO 36 AUTO design
PRO 36 AUTO Operator’s Manual
3
1
6
m
m
(
1
2
.4
’’)
313 mm (12.3’’)
221 mm (8.7’’)
arbor
spoke handle
carrying handle
control panel
electromagnetic base
chip guard
bottle valve lever
opening for safety strap
cooling system bottle
4
261 mm
Содержание Pro 35 Auto
Страница 15: ...15 NOTES...
