12
START UP AND OPERATION
PRO 36 AUTO
Figure 7.
Securing the drilling machine using the safety strap
When working in the position from Figure 7a, mount the cooling system bottle as
described before and
fill
it
with
a
cutting
fluid. Do not use pure water as the cutting
fluid, however, using emulsions formed from mixing water and drilling oil is also
satisfactory. To check the operation of the cooling system, slightly loosen the bottle
cap, open the valve using the lever, and initially apply pressure on the pilot pin by
rotating the spoke handles counterclockwise. The fluid should fill the system and
should begin flowing from the inside of the cutter.
Enter into manual feed mode by positioning the spoke handles as shown in Figure 8a,
and
rotate
them
counterclockwise
to
place
the
tip
of
the pilot pin above the drilling
point.
Figure 8.
Configuration of the spoke handles: manual feed (a), automatic feed (b)
PRO 36 AUTO Operator’s Manual
a)
b)
The cooling system works by means of gravitation, therefore use
a cooling paste when working in horizontal or inverted positions
.
12
PRO 36 AUTO
Figure 7.
Securing the drilling machine using the safety strap
When working in the position from Figure 7a, mount the cooling system bottle as
described before and
fill
it
with
a
cutting
fluid. Do not use pure water as the cutting
fluid, however, using emulsions formed from mixing water and drilling oil is also
satisfactory. To check the operation of the cooling system, slightly loosen the bottle
cap, open the valve using the lever, and initially apply pressure on the pilot pin by
rotating the spoke handles counterclockwise. The fluid should fill the system and
should begin flowing from the inside of the cutter.
Enter into manual feed mode by positioning the spoke handles as shown in Figure 8a,
and
rotate
them
counterclockwise
to
place
the
tip
of
the pilot pin above the drilling
point.
Figure 8.
Configuration of the spoke handles: manual feed (a), automatic feed (b)
PRO 36 AUTO Operator’s Manual
a)
b)
The cooling system works by means of gravitation, therefore use
a cooling paste when working in horizontal or inverted positions
.
12
When working in the position from Figure 7a, mount the cooling system bottle as described
before and fill it with a cutting fluid. Do not use pure water as the cutting fluid. However, using
emulsions formed from mixing water and drilling oil is satisfactory. To check the operation of the
cooling system, slightly loosen the bottle cap, open the valve using the lever, and initially apply
pressure on the pilot pin by rotating the spoke handles counterclockwise. The fluid should fill the
system and should begin flowing from the inside of the cutter.
Enter into manual feed mode by positioning the spoke handles as shown in Figure 8a, and
rotate them counterclockwise to place the tip of the pilot pin above the drilling point.
The cooling system works by means of gravitation,
therefore use a cooling paste when working in
horizontal or inverted positions.
Содержание Pro 35 Auto
Страница 15: ...15 NOTES...
