BA_PH_245-20_EN_15-22.docx
16
Spare parts must meet the technical requirements specified by the manufacturer. The exclusive use of
original spare parts ensures this. Therefore, only use original spare parts from the manufacturer.
Observe the fire alarm and firefighting possibilities. Make the location and operation of fire extinguishers
(fire class ABC) known. Do not use water!
4.2.6
Personnel Selection and Qualification - Basic Duties
The machine design and operation is intended for right-handers.
Work on and with the machine may only be carried out by reliable personnel.
Observe the legal minimum age!
Only use trained or instructed personnel. Clearly define the responsibilities of the personnel for operating,
setting up, maintaining and repairing!
Ensure that only authorised personnel work on the machine!
If personnel to be trained or apprenticed have to work on the machine, this may only be done under the
constant supervision of an experienced resp. qualified person.
Work on the electrical equipment of the machine may only be carried out by a qualified electrician or by
untrained persons under the direction and supervision of a qualified electrician in accordance with the
electrotechnical regulations.
4.3
Safety Instructions for Specific Phases of Operation
Defects and damage to the machine are to be reported immediately after detection.
Any mode of operation that compromises safety is prohibited!
Sufficient lighting around the machine must be ensured (at least 500 Lux)!
4.3.1
Before Working
Clean the machine table from dirt and chips and provide containers for waste pieces.
Only use tools in perfect, sharpened condition and with clean clamping surfaces.
Always check workpieces to be machined for foreign objects, cracks and loose knots.
Only adjust the machine ore fence when the machine is at a standstill.
Required aids such as tool cover, power feeder, table extensions, clamping drawer,
feed devices (e.g. push blog, push stick, bow spring, etc.) and use them as required.
Use a power feeder whenever possible.
Adjust the pressure devices and tool protection covers in the best possible way.
Adjust tools only when the tool is at a standstill using a dial gauge or the "Zeromaster" (option).
Before milling, remove any objects lying on the table (tools, spacers, etc.).
Observe the correct direction of rotation of the tool and avoid dangerous climb milling.
Use a continuous fence for safe workpiece guidance. If necessary, compensate for chip removal
with the partial fence to ensure a continuous fence.
Keep the floor in the area of movement around the machine free of tripping hazards.
Ensure that the machine is connected to an extraction system.
Wear tight-fitting clothing and safety shoes and use safety glasses and ear protection.
If gloves are required for workpiece handling, they must be fingerless.
