BA_PH_245-20_EN_15-22.docx
43
14.2
Functions and Adjustment of the Milling Fences
Two different fence types are available for the 245|20 tilting spindle moulder:
•
Fence Type 216 (standard)
→
Total fence is manually adjustable via handwheel and partial fence via adjusting screw.
→
The handwheel for the total fence is equipped with a digital, battery-operated position indicator.
→
The fence is equipped with cast iron fence plates and aluminium splinter tabs.
→
The fence type 216 can be retrofitted with integral fence plates if required.
•
Fence Type 204 (option)
→
Total fence and partial fence are each manually adjustable via a handwheel.
→
Both handwheels are equipped with a digital, battery-operated position indicator.
→
The fence is equipped with cast iron fence plates and aluminium splinter tabs.
→
The fence type 204 can be retrofitted with integral fence plates if required.
→
This fence cannot be combined with the optional turntable.
Increased risk of accidents and collisions! The adjustment and setting processes
described below may only be carried out when the milling cutter is stationary!
When milling with manual feed, a tool cover must always be used!
Remove chips and dust from the table top before adjusting the milling fence.
For maintenance of your fence, please refer to section
14.2.1
Fence Type 216 (Standard)
Figure 31: Operating elements Fence Type 216
With the optional fence type 216, the
total and partial fence are manually ad-
justable. For adjustment, the clamping
levers (
3
) and (
6
) are released and the
fence is adjusted via the hand wheel
(
2
). Afterwards the two clamping levers
(
3
) and (
6
) must be re-tightened.
The partial fence can be
adjusted by the adjust-
ing screw (
5
) and read
off on the vernier scale.
To visualise the actual position, the dig-
ital handwheel (
2
) of the total fence is
equipped with a position indicator (de-
tails can be found in section
Pos. Description
Pos. Description
1
Total fence plate (cast iron)
7
Aluminium splinter tabs
2
Total fence handwheel adjustment
8
Clamping
4
star grip for fence plate adjustment
3
Total fence clamping lever
9
Sliding covers for high tools
4
Partial fence plate (cast iron)
10
Knurled screws for tool covers (
9
)
5
Partial fence adjusting screw
4
11
Milling protection & pressure device
6
Partial fence clamping lever
12
Protective hood (unlocking rear left)
4
The two star grips (
8
) as well as the partial fence adjustment screw (
5
) are located on the rear side.
6
1
4
7
10
9
5
8
11
3
12
2
