Hohner UNIVERSAL 52/8 S, Инструкции по эксплуатации, список запасных частей, специальные скобы, опции

Страница: 25 / 55

Operation
Hohner Maschinenbau GmbH HK 52/8 S 25
3.2 Feeding the stitching wire
- Fig. 9 -
- Shut off the wire transport (move triangular handle
in the "centre position").
- Push the stitching wire through from above, as follows:
through the eyes of the wire guide - between the two felt disks through into the wire return
lock - through the wire guidance tube and between the two feed wheels .
- Restart the wire transport (turn triangular handle
to the left or to the right).
- Mount adjusting handle .
- Convey the wire to the knife by turning the adjusting handle to the left (clockwise).
3.3 Removing the stitching wire
- Shut off the wire transport (move triangular handle
in the "centre position").
- Press adjusting disk on wire return lock downwards, in order to eliminate its clamping effect,
and pull the wire out.
3.4 Removing the wire guide tubes in the event of a wire jam
If a wire jam has occurred in the area of the wire guide tubes, this can be eliminated more easily
by removing the wire guide tube.
- Shut off the wire transport (move triangular handle
in the "centre position").
- Loosen the clamping screw (Torx screw) and remove wire guide tube
- Disentangle wire and remove from wire guide tubes.
- Press adjusting disk
on wire return lock downwards in order to eliminate its clamping effect
and pull wire out.