Hofmann monty 3550, Руководство по эксплуатации

Страница: 36 / 52

36
4.1.1-5
4.1.1-1
4.1.1-2
4.1.1-3
4.1.1-4
903.tif
899.tif
900.tif
901.tif
902.tif
monty 3550
4.1.1 Use the bead presser as a demounting
help device.
A. In order to make the locking of hard or lowered tires
easier, the operator can use the rim pusher provided with
the bead pusher. Apply the rim pusher (Item 1, Fig.4.1.1-1)
on the bead pusher tool (Item 2), position it at the centre of
the rim (Fig.4.1.1-1) and low the rim as far as the clamps
can lock the rim (Fig.4.1.1-2).
B. Position the roller approx. 2 cm (3/4”) from the rim edge.
Press down the sidewall of the tire to ease the introduction
of the tire bar (Fig. 4.1.1-3). Move the roller to rest position.
To facilitate the lift of the bead on the head tool, position
the lower disk next to the edge of the lower rim edge,
hold fi rmly the arm of the disk and start the lifting of the
device (Fig.4.1.1-4).
Demount the fi rst bead as described in the tire changer
operator’s manual.
C. Position the lower disk next to the lower rim edge. Hold
fi rmly the handle, and at the same time rotate the turntable
(Fig. 4.1.1-5). This operation allows loosening the bead if
this is stuck and helps lifting the tire.
NOTE : A certain effort on the handle of the lower disk in
radial direction is normal to counter-balance
the action of the turntable that pushes the
disk
off the center when rotating.
THE LOWER DISK DEVICE CANNOT BE LOCKED
BECAUSE OF SAFETY REASONS.