Hoffmann MORSO NXLEH, Руководство по эксплуатации

Страница: 7 / 79

7
Instruction Manual
MORSØ Notch Cutting Machine
Model NXLEH
Machine Description
PICTURE C-2:
The MORSØ-NXLEH is constructed as a compact machine with a solid dimensioned frame
(1), with built in hydraulic system (2) and electric equipment (3).
The cutting assembly (4) is placed on top of the machine.
In the slide frame (5) fitted at the cross (6) the knife block (7) is moved up and down. The
cross (6) runs in the guidings of the table.
The knives (8) fitted on the knife block cut not only the notch, but also cope the corners to
complete the joint.
Hydraulic cylinders draw the conveying and the knife block.
PICTURE C-2-1:
The stile is placed on the table (9) against the fixed fences (10). The setting of the moveable
fence (11) to the width of the stile is made by pushing this fence (11) towards the fixed fences
(10) until there is a distance of about 5 mm between the stile and the moveable fence (11)
PICTURE C-2:
The cock-bead stops (12) are adjusted to the required cutting depth. The clamping cylinders
(13) are adjusted to the width of the work piece.
The clamping cylinders are fitted direct on the table.
The adjustment of the flip stops (14) is done by means of a template of the work piece.
The waste is falling via a slide (cover of the hydraulic system) on the floor or in a waste
receiver.
MORSØ-NXLEH can be fitted with nose knives from 12 to 26 mm (1/2” – 1 1/8”).
MORSØ-NXSEH can be fitted with nose knives from 6 to 20 mm (1/4” – 3/4”).
Functional Description C-2