Hoffmann MORSO NXLEH, Руководство по эксплуатации

Страница: 31 / 79

31
Instruction Manual
MORSØ Notch Cutting Machine
Model NXLEH
Adjustment of the Flip-Stops
Making a Template
For setting the flip stop positions a template of the stile (upright section) is made. Mark the
centre of the positions on the cross-rails, incl. the top and bottom rails (see fig. F-6-1) on the
stile.
1. To make the template, put the stile in the machine. For the top and bottom rails always
start cutting from the end of the stile. Feed the section in by 5 mm at each cut (to prevent
break out along the end grain). See fig. F-6-2
2. When a few cuts have been made, align the rail with the set mark and the centre line on
the nose knife (see fig. F-6-1). Make a proper cut in the position.
3. Bring the first stop forward against the end of the template and lock it.
4. Flip this stop over and go to the next position marked on the rail. Make the second cut
and bring the second stop to the same end of the rail. Lock the stop in position. Continue
the procedure until all stops have been positioned and set.
5. When setting the last stop, make a few 5 mm cuts from the end and in (see fig. F-6-2) (to
prevent break out) before setting the stop and locking it.
6. The same template is used to position the stops on the other side. Place the template on
the other side of the knife block up-side-down when setting the stops. Bring the knife
block in bottom position (by means of the setup switch in position 1) into the existing
notch cut outs and position each stop in turn – as described above
.
Operating Instructions F-6