Hoffmann MORSO NXLEH, Руководство по эксплуатации

Страница: 41 / 79

41
Instruction Manual
MORSØ Notch Cutting Machine
Model NXLEH
Changing Knives and Chip Breakers - Adjustment
1. Knife Block (1) is placed in top position. TURN THE MACHINE OFF.
2. The side knives (2) + (3) are dismounted by loosening bolts (6). The nose knife (4) is
dismounted by loosening screws (5).
TAKE CARE OF YOUR FINGERS.
3. The chip-breaker (7) is placed in the angle where the bottom knives meet. The width of
the chip-breaker must be the same as the width of the nose knife (a = b).
NOTE: When changing the chip-breaker (7) the knives must be dismounted.
4. Clean the surfaces of the knife block and the new side knives (2) + (3) very carefully as
even the smallest impurity between side knife and knife block can cause an incorrect
cut.
5. The nose knife (4) which fits the width of the cock-bead of the rail is fitted by means of
the screws (5) on the front of the knife block. Always tighten the top screw first.
6. Both side knives (2) + (3) are fitted with the bolts (6) on the knife block (1). These bolts
must not yet be tightened.
7. The side knives (2) + (3) must meet precisely with the nose knife (4) and neither front
edge must be further ahead (they must balance with the corners of the nose knife).
8. The bolts (6) can now be fastened.
9. Check the length of travel on the knife block (1), by activating the two push button
switches. The nose knife (4) must cut through the chip breaker (7) by only 1-2 mm.
Service G-3