Hoffmann MORSO NXLEH, Руководство по эксплуатации

Страница: 25 / 79

25
Instruction Manual
MORSØ Notch Cutting Machine
Model NXLEH
Adjustment of the Cock-bead Stops
The cock-bead stops (1) are adjusted as follows:
1. Loosen the Allen screws on the cock-bead stops (1) and move these to rear of the sliding
guide.
2. Using a test piece (2) make a notch cut into the cock-bead. This cut must be the same
depth as the cock-bead. The overall width must be equal to the width of the centre cross-
rail. When you are satisfied the two sizes are equal, we can now position and lock the
cock-bead stops (1).
3. The switch (4) must be in position 1. Activate push buttons (5) + (6) in order to bring the
knife block in bottom position. Activate push button (5) to bring the knife block (3) forward
into the previously cut notch. Position the cock-bead stops (1) against the cock-bead and
lock them in place using the Allen screws. When these stops are fixed in position the
knife block (3) can only cut into the cock-bead as far as this setting. The notch cut depth
is then referenced from the face of the cock-bead. The width of stile can vary without
changing this setting.
4. To have the knife block go into top position turn switch (4) into position 0.
5. Check the alignment of the two cock-bead stops (1) using a straight edge. By bringing the
knife block (3) forward, check that they are level and true with the fence.
6. Lock the second Allen screw on the cock-bead stops (1).
7. This setting will allow you to make regularly accurate notch cuts in the stiles. These stops
will need no further adjustment unless the size of the cock-bead changes.
Operating Instructions F-4