NETWORK
How to connect the units
Here is the explanation how to connect the units for the NEWWORK feature.
In the NETWORK feature, there are two kinds of DSR, the master unit distributing the master data and the slave unit receiving the
data.
Setup the NET ID switch
Set up the number of NET ID switch on the rear panel of DSR while the DSR is turned off.
Master unit
--- 1
Slave unit
--- 2 to 9 in order from the master unit
Connect the cable
Connect the 50pin half-pitch cable from the NET OUT connector to the NET IN connector as follows while the DSR is turned off.
NET IN
NET OUT
0
NET ID
USB
NET IN
NET OUT
0
NET ID
USB
NET IN
NET OUT
0
NET ID
USB
Slave unit
NET ID = 2
Slave unit
NET ID = 3
Master unit
NET ID = 1
Maximum number of DSR unit you can connect is nine.
* NET ID = 0 is for the standalone use. If all DSR units are remained connected and set the NED ID = 0, you can use each DSR
as the standalone duplicator.
50