Basic Operations for CD
Copy from disc to disc (CDtoCD)
1. For copying from CD to CD, press the YES switch after confirming the CD main screen as follows.
COPY START?
(DVDtoDVD)
COPY START?
(FAST)
Notice: It is explained as Copy mode. If you want to change mode, refer to “Setup of CD, Select the mode (MODE SELECT)”.
If the master is HDD (displayed “HDtoCD” in the second line), refer to “Copy from HD to disc (HDtoCD)”.
Default of write speed is the maximum write speed of target drive. If you want to change write speed, refer to “Setup of
CD, Select the write speed (WRITE SPEED)”.
2. Press the Yes switch to open the tray of master drive with the following message.
Insert the master disc and close the tray.
INSERT
MASTER DISC
Notice: If the master disc is not inserted within 30 seconds, the screen goes back to 1. The tray does not open if the master disc is
already inserted before pressing the YES switch. It would be the master disc.
3. Tray (s) of target drive opens with the following message. Insert the blank media and close the tray (s). If you do not want to insert
the media to all target drives, close the tray (s) as empty.
INSERT
TARGET DISC
Notice: If any one of target disc (s) is inserted within 30 seconds, the screen goes back to 1.
4. DSR starts to analyze the master disc and the status LED beside the master & target drive (s) starts to blink if it is ready.
ANALYZING
MASTER
5. Copy is started after the master analysis.
COPY 15:25
CD-DA
□□□□
20%
6. Target disc (s) is automatically ejected if the copy completes, the status LED is lit off, and the screen goes back to 1.
☆
Refer to “Notices for CD” for the supported CD formats.
☆
If an error occurs, refer to “Error during process” at the end of this section.
18