19
BATFLY
250 FPV QUAD RACER USER'S GUIDE
Press the FPV OSD Adjust Button on the FPV Video Transmitter to cycle
the position of the FPV Receiver Monitor OSD (On Screen Display) or
to turn it OFF completely. Press and HOLD the FPV OSD Adjust Button to
change the FPV frequency.
USInG ThE FPV SYSTEm
USInG ThE FPV SYSTEm (READY-To-FLY VERSIon), ConTInUED....
1) Fully charge your 3S LiPo battery, then secure it to the back of the FPV
Receiver Monitor, using the Velcro straps provided.
2) Plug the XH balance connector from your LiPo battery into the Power
Input Port. The Power LED should illuminate Green.
3) Make sure that the throttle control stick is all the way back and that the Flight Mode Dial (or the switch on your
transmitter) is in the desired Flight Mode position, then turn the transmitter ON.
4) Place the Quad Racer right-side up on a flat, level surface, then plug your LiPo battery into the Power Connector.
The Condition LED will flash Blue rapidly while a series of audible tones sound.
Do not move the Quad Racer
during this time!
When the Flight Controller is initialized, the Condition LED will flash Blue slowly.
5) Press the FPV Receiver Monitor ON/OFF switch to turn it ON. If no picture
(snow) is displayed on the FPV Receiver Monitor or if the picture is not clear,
press and HOLD the Channel Scan button for 3 seconds, then release it.
The FPV Receiver Monitor will automatically scan the available channels
and lock on the strongest one. A picture should then be displayed on the
FPV Receiver Monitor.
Remember to remove the lens cover from the FPV
camera!
WARNING:
Remember to unplug your LiPo battery from the FPV Receiver Monitor when not in use!
The UP/DOWN angle of the FPV Camera can be adjusted by firmly
moving the top of the camera forward or aft.
THIS SPACE INTENTIONALLY LEFT BLANK
