Hobby-Lobby Telemaster 40 Deluxe, Инструкция по сборке

Страница: 8 / 30

6
c
16
c
15
c
14 The first glue up of the fuselage will con
-
sist of the firewall assembly FW-A&B, the
fuselage floor FF, the F2 assembly, F3,
F4, the wing bolt plate FWBP, the hatch
mounting plate FHMP and the servo tray
FST. Use a slow curing adhesive such
as aliphatic resin to allow time to work.
Glue each part and install it into the right
side. Next apply glue to the left side of all
these components and install the left side.
Place a flat board or other object on this
assembly until it has cured. Make sure all
tabs are bottomed in the notches and all
components fit flush to both sides.
ABOVE: Joining the fuselage side assemblies begins by install-
ing formers, the fuselage floor, wing bolt plate and the forward
hatch mounting plate in one side and then applying glue to the
top side of these components and installing the remaining fuse-
lage side. In the photo, the wing bolt plate and the forward hatch
mounting plate remain to be installed.
Before pulling the tail section together we
need to pre-assemble F9 with FTGM and
F8 with SMP. Use your square to assure
that these components are at 90º to each
other.
ABOVE: The fuselage tail gear mount (FTGM) has been joined
with F9 and the stabilizer mounting plate (SMP) has been
joined with F8
Install the F8 and F9 assemblies at the
same time. Apply glue to both sides of
these assemblies and install. Pulling the
tail section together. It is very important
that these parts be completely inserted
into their respective notches to assure the
stabilizer mount will be level. Use clamps,
tape or rubber bands to assure these
parts fit tightly.
c
13
Install two 1/4” x 20 blind nuts into
FWBP.