Hobby-Lobby Telemaster 40 Deluxe, Инструкция по сборке

Страница: 7 / 30

5
c
12
c
10
c
9 Locate four ¼” x ¼” x 36” sticks, they will
be glued into each corner of the fuselage
aft section. Start with one stick butted up
against FD. Note that the stick must be
glued in line with the inner notches. This
stick will terminate at and to include F9.
ABOVE: The 1/4” square corner stringers are being installed.
One of the pinning blocks is being used to align the stringer
with the edge of the fuselage side.
Install the top corner stringer starting at
the back of FWS and terminating at and
to include F9.
c
11
If you plan to use floats you will need to
install the float hard point. Remove the
dash cut material just behind F4, includ -
ing a notch in the ¼” square stringer.
Assemble F2 from two 1/8” ply sections
using the register pins.
ABOVE: F2 is being assembled on the registration pins, thick
CA is used to laminate the two parts.