Hobby-Lobby Telemaster 40 Deluxe, Инструкция по сборке

Страница: 5 / 30

c
3
3
TRIKE VERSION ONLY
A. Locate NGNP and install four #4-40
blind nuts.
B. Install and glue three NGMB into FW-A
in the slots provided. Use Epoxy or PU
glue for this.
C. Install and glue NGNP to the three
NGMB parts, the blind nuts should be on
the side facing FW-A.
ABOVE: Three nose gear mounting brackets (NGMB) are be-
ing installed into the firewall assembly. BELOW: The nose gear
nut plate NGNP has been installed onto the three nose gear
mounting brackets and the nylon nose gear bearing has been
installed.
c
4
The fuselage sides are supplied in two
sections, FS-A and FS-B, they are joined
by a finger joint at the front. Place the
parts over a piece of parchment paper
and apply thin CA. Wipe off any excess
glue and sand out any bumps.
ABOVE: A straight edge is being used to force
the two fuselage sections flat against the building
board while thin CA is being applied.
BELOW: The finished finger joint.