16
c
15 Use the register pins to position the top sheeting and glue it into position. Use tape or weights to
hold it in position until the adhesive has set.
c
16 Install and glue WP-LE into position on the leading edge.
c
17 Plane and sand LE to contour with the ribs.
This completes the assembly of the wing platform.
c
2
Test fit but DO NOT Glue this assembly into the opening provided in WP. When installed correctly
it should fit flat on WP. Epoxy this permanently in position After covering the model.
c
19
Locate the wing hook parts, two WH-A and one WH-B. Use the register pins to laminate these
parts with one WH-A on either side of WH-B.
c
18
Wing assembly
Lay one of the wing plans on the bench and cover it with a piece of waxed paper. You will be
building the wing over the plans. If the plans are slightly out of size, do not be concerned. The
paper they are printed on will shrink and stretch with changes in humidity and temperature. The
parts will always determine the correct location of components so only use the plans to insure
alignment and location of parts. Place the plans with the leading edge of the wing away from the
edge of the bench you will be working from. We will begin by building the LEFT wing. Some of
the procedures will be reversed for the right wing.
c
1 Locate and prepare one false leading
edge (FLE).
Align a straight edge with the aft edge of
FLE on the plans and secure it in this po-
sition with push pins.
c
3 Place FLE in front of the straight edge,
note alignment lines at the front of W2 on
the plans. Align the notch in FLE with the
lines in front of W2 and use a pinning tab
to press FLE up against the straight edge.
Tack glue the pinning tab to FLE and then
secure the tab to the building board with
push pins.
c
4 Moving down the wing, install a pinning
tab in the same manner at every other rib.
This will secure the false leading securely
to the building board and insure a straight
wing. Make sure it is flat on the building
board.
Содержание Telemaster 40 Deluxe
Страница 2: ......
Страница 29: ...27 ...
Страница 30: ...Hobby Lobby International 5614 Franklin Pike Circle Brentwood TN 37027 USA Phone 866 512 1444 ...