Installation
2-4
© 2005 HMS Industrial Networks
AB7665 User manual
Connecting J1939
The J1939 network connection is a 5-pin terminal block located next to the power
connection on the end of the module. The female terminal block connector is pro-
vided with the Anybus-X. Connections to be made are illustrated in Figure 2-3.
The CAN High and Low signal lines should be connected to the CAN High and
Low connections respectively on all devices on the network. The signal lines
should not be swapped on any device connections.
Note:
The 24VDC terminals on pins 1 and 5 are physically connected to the
power on the 2-pin power connector. The module may alternatively be powered
from these pins.
Figure 2-3 J1939 Connection
24VDC +
24VDC Common
J1939 CAN High
J1939 CAN Low
J1939 CAN Shield
