HLC MHL 23, Руководство по эксплуатации

Страница: 15 / 64

15
For changing the program step displayed, press ok . A value between 1 and 30 can
be selected using buttons
+
and
–
. Confirm your entry by pressing ok and the next
field "hours" will be blinking. If in the field "minutes" no entries are to be made,
select the next field by using the
–
(down) button.
Hours = Duration of the section in hours.
If no changes at "hours" are to be made, select the next field by using the
–
(down)
button. For any changes press ok ; the ones column is highlighted and can be
changed with buttons
+
and
–
. For changing the tens column use button for mark-
ing and
+
and
–
for changing. Confirm your entry by pressing ok and the next field
"minutes" will be blinking.
Minutes = Duration of the section in minutes.
For entries press ok ; the tens column is highlighted and can be changed by using
buttons
+
and
–
. For changing the ones column use button for marking and
+
and
–
for changing. Confirm your entry by pressing ok and the next field "temp °C" will be
blinking.
Time "endless"
If a program step (normally the last one) shall be running without a time setting
until the program will be completed manually, i.e. endless, the hours and minutes
must be set to 00.
Temperature = Set temperature of the section.
The temperature set value is 37°C as standard. If no changes are to be made, select
the next field by using the
–
(down) button. To change this value press ok . Every
single digit can be changed. The cursor is placed at the tens column of the set value.
This value can be changed with buttons
+
and
–
. To change another digit in this
data field, it must be marked by buttons
<
and
>
. The highlighted value will be
changed with button
+
or
–
. After setting the value it must be confirmed with ok ;
the field "rising time" will be blinking.
Rising time = Time setting for tempering the sample to set temperature. This set-
ting is only required if the sample is to be tempered slower than in presttings of the
device. If the sample is to be tempered as fast as possible, set the value to 0.
With "rising time" the heating or cooling speed compared with the normal speed