Hiwin 25.12345, Руководство по сборке

Страница: 24 / 64

24
Assembly and connection
Assembly Instructions
Linear Tables HT-L
HTL-01-0-EN-1905-MA
6.
Assembly and connection
Danger of impacts and crushing!
Uncontrolled or manual carriage movements may cause injury.
X
Isolating protective equipment must be provided for linear table operations!
X
Only qualified personnel may be assigned to commissioning, setup, and troubleshooting!
WARNING!
Danger of impacts and crushing!
Uncontrolled movements by the powered elements of the linear tables may cause injury.
X
Controller design complying with DIN EN 12100. No start after
– power connected, reinstated!
– troubleshooting!
– machine stop!
WARNING!
Warning! Damage to hearing!
The linear tables can generate noise in excess of 70 dB(A) at high speeds.
X
Hearing protection must be worn when high speed linear tables generate noise greater than 70 dB(A)!
CAUTION!
Danger from suspended loads or falling parts!
X
Only qualified personnel may assemble, install, and service the linear tables!
X
Note the mass when transporting the parts. Use suitable hoisting gear!
X
Observe the applicable occupational health and safety regulations when handling suspended loads!
X
Hoist the linear tables only at the designated points!
X
Secure machinery and machine parts against tilting!
X
Secure the linear tables as described in the assembly instructions!
CAUTION!
Danger of impacts and crushing due to imposed load becoming detached!
If the fastener is fastened incorrectly or fails, injuries can be caused by falling or flying parts.
X
Your assembly must ensure that parts cannot detach even under high accelerations or constant vibra-
tions!
X
Secure the imposed load as described in the assembly instructions!
CAUTION!
Danger of cutting injuries!
Installing or removing the cover strip may cause cutting injuries.
X
Only qualified personnel wearing appropriate protective equipment (gloves, goggles) may be assigned to
commissioning and setup!
WARNING!
Danger of impacts and crushing
If the axes are moved by the motor, injuries can be caused by moving axes and attachments (energy chains,
attachments installed by customer).
X
Isolating protective equipment must be provided for linear table operations!
CAUTION!