Hitachi RAC-25CNH11, Руководство по обслуживанию

Страница: 59 / 108

– 68 –
●
DC 230V is input to power module and power module switches power supply current according to rotation
position of magnet rotor. The switching order is as shown in Fig. 3-2.
E
F
U V V W
Upper arm
transistor
Lower arm
transistor
Time
+ +
T
+ +
T
W —
—
U — U — V —
U transistor chopped U transistor ON
ON
Voltage between
Upper arm transistor
current at
Chopping period
Chopping period
and
260V-380V
A
+
B
B
W
[ ]
●
Upper arm transistor is controlled to ON/OFF by 3.2kHz chopper signal. Rotation speed of the compress
is proportional to duty ratio (ON time/ ON time + OFF time) of this chopper signal.
●
Time T in Fig. 3-2 shows the switching period, and relation with rotation speed (N) of the compressor is
shown by formula below;
Fig. 3-2 Switching order of power module
N = 60/2 X 1/T
●
Fig. 3-3 shows voltage waveform at each point shown in Figs. 3-1 and 3-4.
Fig. 3-3 Voltage waveform at each point
●
When power is supplied U+
[
U–, because of that U+ is chopped, current flows as shown below; B
(1) When U+ transistor is ON: U+ transistor
[
U coil
[
V coil
[
V– transistor
[
DC current detection
resistor
[
Point B (Fig. 3-1)
When U+ transistor is OFF: (by inductance of motor coil) U coil
[
V coil
[
V– transistor
[
Return diode
[
Point A (Fig. 3-4)
*
At point E: U+ is ON, V– is ON (circuit in Fig. 3-1)
*
At point F: U+ is chopped (OFF), V– is ON (circuit in Fig. 3-4)