5 - 12
Disassembly and Reassembly > Disassembly
(13) Camera Block
1) Remove the screw [B].
Note:
Take great care when handling the camera
block: The camera block contains the lens unit,
which is a precision component. Subjecting the
lens unit to any impact, however slight, could
result in a fault.
Fig. 5-3-13
[B] M1.7×2.5
(Silver)
1) [B]
(a)
(14) Disc Drive Unit and R Case
1) Disconnect the fl at cable.
2) Remove the two screws [A].
3) Remove the two screws [D], and then remove the disc drive unit (a).
Note:
The disc drive unit is a precision component: Take great care when handling it. Do not subject the
disc drive unit to any impact: Doing so could cause a fault.
Caution during disassembly and reassembly:
Be sure to paste the heat sink rubber (c): Neglecting this could cause a fault.
Fig. 5-3-14
1)
2) [A]
3) [D]
Unlock
Pull out
(a)
(c)
(b)
[D] M1.7×4
(Black)
[A] M1.7×4
(Silver)
(a) Camera block
(a) Disc drive unit
(b) R case
(c) Heat sink rubber
