Connecting the Computer Cables
4-3
10Base2 (ThinWire) BNC
To connect the printer within a segment of the cable:
1.
Use a BNC T-adapter to connect to the Ethernet cable connector.
2.
Attach the BNC T-adapter to the Coax BNC connector on the back of
the printer.
To connect the printer to the end of a cable segment:
1.
Connect the Ethernet cable connector to one end of a BNC T-adapter.
Make sure that both ends of the network cable are terminated with
50 ohm terminators.
2.
Attach the BNC T-adapter to the Coax BNC connector on the back of
the printer.
RJ45 Unshielded Twisted Pair (UTP)
Attach one end of the twisted-pair cable to the RJ45 wall outlet, adapter
(DB15), or other 10BaseT Ethernet source.
For complete communications between the Network Series Print Server
and the host or a network hub, the link test state (enabled or disabled) must
be set the same on both. The Network Series Print Server is always set
enabled.
Within Segment Connection
End Connection
Terminator
Содержание DDS 32
