7
Installation of Washing Machine
ᘺ⠥ᑨ᱿મ⡶
Please install on a solid horizontal surface.
⦼મᄍ߱ᶶȮ౹ࠎ᱿߸ㄇʀȯ
• Installation on a slippy or irregular surface may result in noise and shaking.
મᄍ߱ᆞᅠՒȮⰖ᱿߸ㄇʀŊሳૌᆞᮟᮝྚՒُݿㅠȯ
The unit should be installed on a fl at horizontal surface.
⦼ᖛ౹મ⡶ᘺ⠥ᑨȯ
Otherwise sudden stop or abnormal sound may occur
during the spinning cycle.
મ⡶വʃᖛ౹Ŋሳ⎐⌉ᖛᆹϟᑨᮟᮝᯌ⊖ㅠȯ
Where to install
મ⡶߸ᅞ
Solid, horizontal surface
ᶶȮ౹ࠎ᱿߸ㄇ
Weak surface
Ⱆ᱿߸ㄇ
Irregular surface
Ӛә᱿߸ㄇ
At least 1.5cm
1.5cm
˫ʀ
At least 1.5cm
1.5cm
˫ʀ
At least 9cm(Water drainage hose onside)
9cm
˫ʀ(ᖛᾷɺϳ)
Avoid installing the unit too close to the wall.
⦼խㄅⲖᦷࣦમᄍȯ
• This is to prevent abnormal vibration and noise.
˫〾ᔋᯌྚՒُݿㅠȯ
How to install
મ⡶ᅞᘍ
1
Put the washing machine at the installa-
tion place.
༴ᘺ⠥ᑨᄍ⇦߱મ⡶ࢍȯ
•
Make adjustment according to the following steps if
the washing machine is not put on a flat horizontal
surface or there's gap under the leg:
ॖኞᘺ⠥ᑨᄍ⇦വʃ౹Ȯᑨ⌳ʁሷ⿵めŊרྈᤫʁⲩ
ᔎ㊾⦲ῃŘ
•
Heighten the adjustable leg till no gap exists at its side.
ר⦲ᑨ⌳ɺϳሷ⿵めᆹ⦲㋧ר⦲ᑨ⌳Ŋᚉぜ⿵めȯ
•
ר⦲ᑨ⌳᱿ଃㄇɺϳሷ⿵めᆹ⩕രϳ᱿⌳┮߸Ŋᮢ⳺
ᯍ᱿ኈቨ⻎ࣆ߱Ԋϳ᱿⌳⎞߸ㄇʠ⿵Ŋᚉぜ⿵めȯ
Check the bubble location on the horizon-
tal indicator.
ᒑውᖛ౹я᱿ᖎᘗ̤⇦ȯ
•
No leg adjustment is required if the bubble is right at
the circle center.
ॖኞᖎᘗᔌ॑߱ߥߞ᱿ʑतŊ⌳ଔʃト⣬⦲ῃȯ
Circle
ߥ
Bubble
ᖎᘗ
•
Adjust height with the adjustable leg if the bubble is
not in the circle.
ॖኞᖎᘗʃ߱ߥߞʑŊᮢר⦲ᑨ⌳⦲ῃ㋧ಙȯ
2
Observe the horizontal
indicator from above.
Ʃ⣬ഺʀᅞ᳖ᖛ౹яȯ
3
According to the bubble location on the
horizontal indicator, rotate the adjust-
able leg to locate the bubble at the
circle center.
ዾჇᖛ౹я᱿ᖎᘗ̤⇦ŊᅩⱧר⦲ᑨ⌳Ŋ͐
ᖎᘗ⎏ᅠߥߞʑतȯ
If the bubble is out of half of the
circle radius, the ground is too
sloppy to be regulated to flat with
only the adjustable leg.The plank
shall be properly inserted.
Check the existence of gap under the
washing machine leg.
ᒑውᘺ⠥ᑨ⌳ʁᆯ؋ሷ⿵めȯ
Remove the horizontal indicator. Close the lid.
חӛᖛ౹яŊ〦ᑨ╾ȯ
•
If gap exists, adjust the adjustable leg.
ॖኞሷ⿵めŊᮢר⦲ᑨ⌳Ⳗ⠗⦲ῃȯ
plank
ኈቨ
4
5
Lowering
⦲̥ᆹ
Loosening
ᅩ㌂
Lock nut
⽁ℤ
䴚
ᕒ
Adjustable leg
Elevating
⦲㋧ᆹ
Tightening
ᅩℤ
Lock nut
⽁ℤ
䴚
ᕒ
If there's gap opposite to the adjustable leg, make the rear
leg stand closely on the ground, and insert proper plank
between the front leg and the ground to fill up the gap.
ॖኞᖎᘗϘӛߥߞɺ֚˫ʀŊ
ଔᆯ߸ㄇ᱿РᅈಙठञŊʃ
⋱܈ᮢר⦲ᑨ⌳⦲ῃȯרᮢ⳺ᯍ
᱿ኈቨ⻎ࣆȯ
Installation of the bottom plate
ಎኈ᱿મ⡶
1
Please lay down the
washer slowly.
⦼૽ᑨ㋤ⱀⱀ߸ᄍΪȯ
The bottom plate is placed on the packaging foam on the top of the washing machine.
ӛೇᆹŊಎኈમᄍ߱ᘺ⠥ᑨㅫⵒ᱿ծ⡶ᱹᘗʀȯ
2
Align the hook on the bottom plate with the
square hole on the chassis and insert it, and
then tighten the screw.
૽ಎኈʀ᱿ΪଃಎᲷʀ᱿ᅞઋတҘŊᤋരეℤ➦⸎ȯ
Installation Guide
મ⡶྆֡
Attention
ᘜา
• Carpet does not obstruct
the openings for washing
machines with ventilation
openings in the base.
߸ᕧʃ⣬ࢎࢩⳇㆺםȯ
Содержание BW-V80BS
Страница 59: ...Јൡ ...