Hisun HS700UTV-4, Руководство по обслуживанию

Страница: 42 / 388

GENERAL INFORMATION
- 29 -
NOTE
Unless otherwise specified, install
bearings with the manufacturer’s
mark or number facing outward.
Removal
While bearing are normally removed only when
damaged, there may be times when it is necessary to
remove a bearing that is in good condition. However,
improper bearing removal will damage the bearing and
possibly the shaft or case. Note the following when
removing bearings:
1. When using a puller to remove a bearing from a
shaft, take care that the shaft is not damaged.
Always place a piece of metal between the end
of the shaft and the puller screw. In addition,
place the puller arms next to the inner bearing
race. See
Figure 42.
2. When using a hammer to remove a bearing from
a shaft. do not strike the hammer directly against
the shaft. Instead, use a brass or aluminum rod
between the hammer and shaft
(Figure 43) and
make sure to support both bearing races with
wooden blocks as shown.
3. The ideal method of bearing removal is with a hydraulic press. Note the following when using a
press:
a. Always support the inner and outer bearing
races with a suitable size wooden or
aluminum spacer
(Figure 44). If only the
outer race is supported, pressure applie
against the balls and/or the inner race will
damage them.
b. Always make sure the press arm (Figure
44) aligns with the center of the shaft. If the
arm is not centered, it may damage the
bearing and/or shaft.
c. The moment the shaft is free of the bearing. It drops to the floor. Secure or hold the shaft to
prevent it from falling.
Installation
1. When installing a bearing in a housing, apply pressure to the outer bearing race (Figure 45).
When installing a bearing on a shaft, apply pressure to the inner bearing race (Figure 46).