Hisense HYE-W01, Руководство по обслуживанию

Страница: 114 / 229

Wireless Receiver Kit
2) Optional Setting for Dip Switch (SW3)
1 2 3 4
Setting of Sub Receiver Kit
Identifying of Indoor Units
: ON, : OFF
Dip Switch Setting (SW3)
Operation Function
emergency operation
Emergency Operation Setting (Refer to the figure of the item 3 “Optional Functions”.)
In case that wireless remote control switch is unusable by batteries shortage, etc., perform
1) Proceed the “TEST RUN” mode by using “Operation & Installation Manual” for the wireless remote
control switch.
#
Turn OFF all power sources before setting the dip switches.
2)
(1) Switch “COOL”: Press “COOL” so that the cooling operation is started.
Press “COOL” again so that the cooling operation is stopped.
(2) Switch “HEAT”: Press “HEAT” so that the heating operation is started.
Press “HEAT” again so that the heating operation is stopped.
NOTE:
During the emergency operation, the LED (yellow) blinks (0.5 second ON / 0.5 second OFF).
3) Alarm Code Indication
• In case that some trouble occures because of activation of safety device, etc., “RUN” (red lamp)
blinks (0.5 second ON / 0.5 second OFF).
• Refer to the Installation Manual for outdoor unit about Alarm Code List.
• Alarm Code indicates the blinking times of “DEF” (green lamp) and “FILER” (yellow lamp) as shown
bellow.
“DEF” (green lamp):
The blinking is shown at the 2 digit of Alarm Code
“FILTER” (yellow lamp): The blinking is shown at the 1 digit of Alarm Code
(Alphabet Code: A=10 times, B=11 times, C=12 times, .....)
4. Others
as follows.
- Example -
• “Run” (red lamp) blinking (1 second ON / 1 second OFF) indicates abnormal transmitting between
Indoor Units and Outdoor Unit.
Alarm
3 5
"FILTER" (yellow lamp)
"DEF" (green lamp)
"DEF" blinks 3 times (0.5 second ON / 0.5 second OFF)
"FILTER" (yellow lamp) blinks 5 times (0.5 second ON / 0.5 second OFF)
105