Hirschmann OCTOPUS 16M-Train-BP, Руководство пользователя

Страница: 7 / 48

Installation OCTOPUS 8M/16M/24M/OS32
Release 16 06/2018
7

Supply voltage
The devices are designed for operation with safety extra-low voltage.
Connect only SELV circuits with voltage restrictions in line with IEC/EN
60950-1 to the supply voltage connections and signal contacts.
The supply voltage is electrically isolated from the housing.

Only use voltage supply cables with the permitted diameter specified
by the manufacturer of the right angled cable socket.

Relevant for North America:
Devices without Power-over-Ethernet (PoE) may only be connected to
a supply voltage of class 2 that fulfills the requirements of the National
Electrical Code, Table 11(b). If the voltage is being supplied
redundantly (two different voltage sources), the combined supply
voltages must fulfill the requirements of the National Electrical Code,
Table 11(b).

Relevant for North America: For use in Class 2 circuits.
Only use copper wire/conductors of class 1, 75 °C (167 °F).

E marking
(Relevant for OCTOPUS 8M-8PoE, OCTOPUS 8M-6PoE, OCTOPUS
16M-8PoE, OCTOPUS 24M-8PoE)
The labeled devices comply with the regulations contained in the following
European directive(s):
72/245/EEC
Council Directive on the approximation of the laws of the Member States
relating to the suppression of radio interference produced by sparkignition
engines fitted to motor vehicles.
2009/19/EC
Commission Directive amending, for the purposes of its adaptation to
technical progress, Council Directive 72/245/EEC relating to the radio
interference (electromagnetic compatibility) of vehicles.
Devices with an approval are labeled with the E type-approval mark .
(Relevant for OCTOPUS OS32...)
Regulation No. 10 of the Economic Commission for Europe of the United
Nations (UN/ECE):
Devices with an approval are labeled with the
E type approval mark.
Note: For use in connection with a suitable type approved power supply
only.