Hirschmann OCTOPUS 16M-Train-BP, Руководство пользователя

Страница: 19 / 48

Installation OCTOPUS 8M/16M/24M/OS32
Release 16 06/2018
19
1.6 Display elements
After the supply voltage is set up, the software starts and initializes itself.
Afterwards, the device performs a self-test. During this process, various
LEDs light up. The process takes around 60 seconds.
Figure 1: Display elements
1 - Port status LEDs (here: for ports 1 to 4)
2 - Device status LEDs
1.6.1 Device state
These LEDs provide information about conditions which affect the operation
of the whole device.
If the manual adjustment is active on the “FAULT” signal contact, then the
detected error display is independent of the setting of the signal contact.
LED Display Color Activity Meaning
P1 Supply voltage 1 Green Lights up Supply voltage is on
None Supply voltage is too low
P2 Supply voltage 2 Green Lights up Supply voltage is on
None Supply voltage is too low
FAULT Signal contact Red None The signal contact is closed - it is not
reporting any detected errors.
Lights up The signal contact is open - it is reporting
a detected error.
RM Ring Manager — None The RM function is deactivated.
Green Lights up The RM function is active.
The redundant port is disabled.
flashing The device detects an incorrect
configuration of the HIPER-Ring (e.g. the
ring is not connected to the ring port).
Yellow Lights up The RM function is active.
The redundant port is enabled.
OCTOPUS
1
2