2.2
Installing and grounding the device
2.2.1
Installing the device
WARNING
ELECTRIC SHOCK
Install this device solely in a switch cabinet or in an operating site with
restricted access, to which maintenance staff have exclusive access.
Failure to follow this instruction can result in death, serious injury,
or equipment damage.
To protect the exposed uninstalled contacts of the components from dirt,
connect the individual system components in a dry and clean working area.
Prepare the drill holes at the installation point.
Mount the device on a level surface with four M6 screws.
To preserve the suitability of your device for IP65/67, proceed as follows:
Remove the provided transport protection caps and the transport
protection screws from the device.
Seal unused sockets and plugs with your desired type of protection
screws which you can order separately.
2.2.2
Grounding the device
Grounding the device is by means of a separate ground connection on the
device.
The overall shield of a connected shielded twisted-pair cable is connected to
the metal housing as a conductor.
The device variants have a connection for protective grounding.
Note:
Use toothed washers to ensure good electrical conductivity at the
connection.
Ground the device via the provided M4 screw.
Installation BATOne
Release 01 01/2019
26
