Hioki RM2610, Инструкция по эксплуатации

Страница: 32 / 138

28
Connecting the Z2001 Temperature Sensor
2.6 Connecting the Z2001 Temperature Sensor
Connecting the Z2001 Temperature Sensor to the RM2611 Electrode
Resistance Meter
When connecting the Z2001 Temperature Sensor to the RM2611 Electrode Resistance Meter,
insert the connector firmly as far as it will go.
1
2
1
Verify that the RM2611 Electrode
Resistance Meter’s main power switch (on
the rear of the instrument) is in the OFF (○)
position.
2
Connect the Z2001 Temperature Sensor to
the TEMP.SENSOR terminal on the rear of
the RM2611 Electrode Resistance Meter.
Connecting the Z2001 Temperature Sensor to the RM9003 Press Unit
1 2 3
1 cm
1
Remove the temperature sensor mounting
screw on the RM9003 Press Unit.
2
Insert the Z2001 Temperature Sensor into
the temperature sensor mounting clamp
on the RM9003 Press Unit.
(Insert the wire until the base of the
sensor unit protrudes about 1 cm past the
clamp.)
3
Tighten the screw on the RM9003 Press
Unit’s temperature sensor mounting
clamp.