ENGINE MECHANICAL (J08E)
EN02–46
(2)
For the jet test, connect the oil hose to the connector bolt from the cyl-
inder block lower side.
NOTICE
Use clean engine oil for jet flow.
(3)
Set the special tool on the cylinder block upper surface against the
dowel pin.
SST: Gage (09219-E4010)
(4)
Test jet oil flow from the piston cooling jet nozzle at a hydraulic pres-
sure of 245 kPa {2.5 kgf/cm
2
, 35 lbf/in
2
}.
(5)
If the center of the jet flow is within the two target circles (8 mm
{0.3150 in} and 15 mm {0.5906 in} diameter: Red), the test is accept-
able.
! WARNING
•
Engine oil is flammable.
•
Never use an open flame or a naked bulb.
•
Carry out the following inspection only in a well-ventilated area.
(6)
If the center of the jet flow is out of the two target circles, adjust or
replace the jet.
SHTS011060200136
SHTS011060200137
SHTS011060200138
Содержание J08E-VC
Страница 130: ...EXHAUST SYSTEM J08E EN04 9 TAIL PIPE STACK TYPE 11 6 G 13 2 3 F 12 8 E 8 4 B 10 A 1 9 5 7 C C E D 13 G SAPH011060400009 ...
Страница 150: ...EXHAUST SYSTEM J08E EN04 29 SAPH011060400054 ...
Страница 176: ...LUBRICATING SYSTEM J08E EN05 2 LUBRICATING SYSTEM DIAGRAM EN0110605J100001 SHTS011060500001 ...
Страница 205: ...FUEL SYSTEM J08E EN07 4 SUPPLY PUMP DESCRIPTION EN0110607J100002 1 SAPH011060700003 1 Supply pump assembly ...