Hilti DS TS20-E 1.6, Руководство по эксплуатации

Страница: 32 / 36

32
Troubleshooting
Display Er01 The machine doesn’t function Faulty connection between – Check plug connectors and cable
Er02 correctly the remote control and power – Replace the remote control unit
unit – Return remote control and
power unit to Hilti Service
Display Er04 The machine doesn’t function Fault in the remote control – Replace the remote control
Er05 correctly electronics – Return the remote control to
Er06 Hilti Service
Er07
Display Er12 Machine cannot be switched Break in the connection between – Check the control cable and
on the power unit and the saw head plug connections
– Return the saw head, control cable
and power unit to Hilti Service
Display Er30 The machine has switched The slip clutch has been – Observe the application guidelines
itself off activated as a result of how the – Return the saw head to Hilti
saw is being used Service
Display Er33 The machine has switched Saw used incorrectly - overload – Observe the application guide-
itself off Saw blade stuck lines
Short circuit – Return the saw head, cable and
power unit to Hilti Service
Display Er35 The machine has switched Saw used incorrectly – Observe the application guidelines
itself off Excessive lateral friction – Return the power unit to Hilti
Blade segments polished Service
Display Er36 Saw blade cannot rotate Saw blade stuck – Release the blade / restart
– Return the power unit to Hilti
Service
Display Er40 The machine has switched itself off Electric supply voltage too high – Check the electric supply
Display Er41 The machine has switched itself off Electric supply voltage too low – Check the electric supply
Display Er80 The machine doesn’t function Electronic fault in the power unit – Return the power unit to Hilti
correctly Service
Display Er81 The machine doesn’t function Electronic fault in the power unit – Return the power unit to Hilti
Er82 Service
Display Er83 The machine doesn’t function Electronic fault in the power unit – Return the power unit to Hilti
Er84 Service
Display Er85 Machine cannot be switched Contactor K1 or K2 in the – Return the power unit to Hilti
Er86 on power unity is faulty Service
Er87
Er88
Display Er91 The machine doesn’t function Safety loop for emergency stop – Replace the remote control
is faulty
– Return power unit to Hilti Service
Causes of faults with no error code and how they can be remedied
Description of fault Possible cause Recommended measures to remedy the fault
Blade wanders off course Inadequate blade tension Check the tension / replace the blade
Saw blade segments have lost cutting power Check the specification / replace the blade
No guide cut made or guide cut not straight Observe instructions and guide values
Play at the guide rollers Check the play / replace the rollers or rail
Rail not securely fastened Check and improve the fastenings
Rail distorts (twists) Install additional rail supports
Low sawing performance Unsuitable saw blade specification Check the specification / change to other
specification if possible
Depth of cut too high Check depth of cut / reduce if possible
Power setting too low Check the setting / increase if possible
10.2
Printed: 09.03.2015 | Doc-Nr: PUB / 5139344 / 000 / 01