17
Setting up the wall saw system
235mm
235mm
235mm
230mm
183mm
274mm
139mm
139mm
max. 50 cm
max. 170 cm
max. 100 cm
4 3 2 m m
2 3 0 m m
3 6 1 m m
1 3 9 m m
595mm
736mm
176mm
176mm
250mm
74 mm
1. Mark the positions of the anchor holes for the rail supports.
2. Drill the anchor holes (depth and diameter in accordance with the manufacturer’s instructions).
3. Clean the holes (remove the drilling dust).
4. Insert and expand the anchors (e.g. Hilti HKD-D M12) using the setting tool.
5. Screw in the fastening screws (8.8 grade with collar nut, supplied in the accessory box) to their full depth by hand.
6. Position and align the rail supports and then tighten the collar nuts slightly.
Anchor hole distance
Main dimensions of the DS TS20-E (in mm)
Fitting the rail
1. Fit the rail clamp to the rail.
2. Position the rail with fitted rail clamp on the rail support and close the clamping plate.
3. Turn the rail support until at right angles to the rail and then tighten the clamping plate securely.
4. Compensate for any difference in level by adjusting the leveling screws.
5. Align the rail at the correct distance from the cutting line and then tighten the fastening screws.
6. Fit end stops at both ends of the rail.
NOTE
The rail clamps cannot be used with the rail supports for angular cutting.
7.3
Maximal permissible rail support distance
Printed: 09.03.2015 | Doc-Nr: PUB / 5139344 / 000 / 01
