22
Setting up the wall saw system
Fitting the blade guard
NOTE
■
Should it prove impossible to use the blade guard due
to specific circumstances at the working area, spe-
cial measures must be taken, such as construction
of a temporary enclosure (e.g. using forming boards),
to protect the surrounding area from flying fragments
etc. while sawing.
■
Use the DS-FCA flush-cutting flange and flush-cut-
ting blade guard (available as accessories) for flush-
cutting applications.
■
Keep the holes for the side section guide pins clean
in order to prevent sticking of the side sections.
■
Keep the blade guard clean. Clean it regularly each
time after use to ensure that it remains in good wor-
king order.
CAUTION
Remove the side section only immediately before begin-
ning a corner cut.
1. Push the center section of the blade guard
, or the
complete blade guard, onto the blade guard holder
.
2. Fit the blade guard side section by engaging the met-
al hooks
with the center section
and then close
the clamp
. Secure the blade guard to the blade
guard holder by pulling the rubber strap over the ten-
sioning lug.
3. To remove the side section
, open the clamp
and
lift the side section away from the center section
.
7.9
Parts
No.
Designation
Blade guard center section
Blade guard side section
Guide pin
Blade guard holder
Guide rollers
Clamp
Tensioning lug
Rubber tensioning strap
1
5
4
2
3
8
7
6
Printed: 09.03.2015 | Doc-Nr: PUB / 5139344 / 000 / 01
