![background image](http://html1.mh-extra.com/html/hilti/ds-ts20-e-1-6/ds-ts20-e-1-6_operating-instructions-manual_2136338020.webp)
20
Setting up the wall saw system
Parts
No.
Designation
Clamping lever
Release button
Guide roller
Guiding surface
Adjusting the blade guard
1. Release the clamping screw
on the saw arm.
2. Pivot the blade guard holder
into the desired position.
3. Tighten the clamping screw
.
7.6
Parts
No.
Designation
Blade guard holder
Clamping screw
Hex. socket wrench, 8 mm AF
Connecting the power cable, remote control unit and cooling water hose to the power unit and saw head
CAUTION
■
To avoid damage to the parts, check that the plug and socket are clean and in good condition before connect-
ing. Clean the parts or remedy any damage before connecting them.
■
When unplugging, always grip the plug and not the cable. Fit the protective cap immediately.
■
Do not use the plug as a grip or carrying handle.
■
Do not allow the cables to become tangled and place them carefully so that the plug connectors are not lying
in water. The cables must be long enough to allow the saw head to move freely.
1. Remove the protective caps.
2. Align the plug carefully with the socket and push it in all the way without using excessive force.
3. Close the securing sleeve and check that it engages.
4. Close the protective caps together.
5. Connect the cooling water hose.
7.7
1
3
2
Printed: 09.03.2015 | Doc-Nr: PUB / 5139344 / 000 / 01